Uline H-10066 Manual De Instrucciones página 11

CLEANING/REPLACING DRIVER BLADE
REQUIRED PARTS
c.561B / c.561B22 Driver Blade (wear part)
M4 Torx Cylinder Screw (1)
DISMANTLING DRIVER BLADE
1. Remove battery from stapler.
2. Remove magazine.
3. Set penetration depth to MIN.
4. Loosen six captive Torx cylinder screws (1) holding
the rear body to the front section. (See Figure 25)
4
5. Pull down the rear body (2) and remove it.
6. Remove driver blade (3).
7. Clean and check driver blade for wear. Replace
if necessary.
FITTING DRIVER BLADE
• Fitting is performed in reverse order.
• When installing driver blade, ensure the "visible
while assembling" signage (4) points outward.
(See Figure 25)
PAGE 11 OF 42
MAINTENANCE CONTINUED
MFG. PART #
164175
946876
Figure 25
3
1
2
CLEANING/REPLACING CLINCHERS
REQUIRED PARTS
c.561B / a.560B Clinchers (wear part)
M4 Torx Cylinder Screw, Housing (1)
DISMANTLING CLINCHERS
1. Remove battery from stapler.
2. Remove magazine.
3. Set penetration depth to MIN.
4. Loosen six captive Torx cylinder screws (1) holding
the rear body to the front section. (See Figure 26)
5. Pull down the rear body (2) and remove it.
6. Remove two Torx cylinder screws (3) and remove
clinchers (4).
7. Always change both clinchers at the same time.
8. Clean and check clinchers for wear. Replace if
necessary. (See Figure 26)
FITTING CLINCHERS
Fitting is performed in reverse order.
MFG. PART #
134340
946876
Figure 26
3
4
1022 IH-10066
1
2