User Interface; Battery And Charger - Uline H-10066 Manual De Instrucciones

USER INTERFACE

1. Battery Charge Status
display. (See Figure 1)
2. Mode Indicators:
MAN, SEMI and AUTO
3. MODE button:
a. One click: select mode
of operation
b. Hold button approximately one second to
activate or deactivate optional laser
TOOL STATUS INDICATOR
DURING STARTUP
• Blue LED pulsating twice
indicates that battery has
been inserted and trigger
has been actuated once.
Tool turns on. (See Figure 2)
DURING OPERATION
• Blue LED slowly pulsating
indicates unit is ready
for operation.
• Green LED on indicates tool
is in stapling position. Box detection is activated
and finger is on trigger (trigger sensor).
• Red LED slowly pulsating or on indicates a
tool error.

BATTERY AND CHARGER

NOTE: For detailed information, refer to the
operating instructions for battery and charger
on page 6.
1
3
4
PAGE 5 OF 42
Figure 1
1
MAN
2
3
Tool Status
Indicator
Figure 2
PARTS
# DESCRIPTION
1 Battery
2 Charger
2
3 Battery Release
4 LED Indicator
SETUP
FUNCTION
The stapling tool is positioned on carton to be closed
(box detection sensors activated). (See Figure 3)
• Actuating the trigger starts the stapling process.
• During downward movement of driver blade (1),
a staple (2) is sheared off the staple strip.
• The staple is pushed into the carton by the driver
blade and bent (4) using the clinchers (3).
• The clinchers and driver blade are released from the
carton in an upward movement and brought into
the initial position.
Figure 3
1
3
NOTE: Three operating modes are available:
Manual, Semi-automatic and Automatic
STAPLE TYPES
• Staple length 5/8" for total carton thickness
0.20-0.35" (S-10720).
• Staple length 3/4" for total carton thickness
0.28-0.47" (S-10721).
NOTE: Stapler comes pre-set at 5/8"
staple length.
NOTE: The staple leg length can be set.
NOTE: The staple penetration depth can be set.
NOTE: The staple clinch can be set.
2
4
1022 IH-10066