Mowing; Working Instructions; Cleaning And Maintenance - Grizzly Tools BRM 46-144 A-OHV Q-360 Traducción Del Manual De Instrucciones Original

GB
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Cold start:
1. Press the fuel pump (
3 times.
2. Pull the safety catch (3) towards
the handle bar and hold it.
3. Pull the starter cord (22a).
4. When the engine starts, allow
the starter handle to slowly slide
back into the starter cable guide
(22b).
Stopping the engine:
5. Release the safety loop (3). The
motor switches off and the knife
is braked.
For a warm start it is not neces-
sary to press the primer (
Regularly examine the knife
stopping device:
Release the safety loop (3). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.

Mowing

1. Start the engine (see
2. Wheel drive:
On: Pull the drive catch (2)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.
88

Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed in
lines that are as straight as possible. For
uninterrupted mowing, the lines should
always overlap by a few centimetres.
30) • Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
30).

Cleaning and Maintenance

Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly Tools replace-
ment parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
). engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!