Cleaning And General Maintenance Work; Replacing The Air Filter; Change / Adjust Spark Plug - Grizzly Tools BRM 46-144 A-OHV Q-360 Traducción Del Manual De Instrucciones Original

Wear gloves when handling the
blade.
Cleaning and General
Maintenance Work
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine as
it could contaminate the fuel system.
• To clean the blade housing, it is possi-
ble to connection a hose to the upper
side of the housing (34) (see
• After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes, ejection hole and
blade area especially. Do not use hard
or pointed objects, which could dam-
age the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that
all nuts bolts and screws are sitting
firmly.
• Check covers and guards for damage
and that they are sitting correctly. Re-
place if necessary.

Replacing the Air Filter

Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine
1. Release the screw at the air fil-
2. Remove air filter (9).
3. Replace a defective air filter
4. To install, place new air filter (9)
5. Close the air filter cover and

Change / adjust spark plug

A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
). 1. Disconnect the spark plug con-
2. Unscrew spark plug (31) coun-
3. Check the spark gap using a
4. If necessary, adjust the gap by
5. Clean the spark plug with a wire
6. Insert the cleaned and adjusted
ter cover (10) and flip open the
cover
with a new filter (see "Spare
Parts").
into the air filter cover (10)
fasten screw again.
nector ( 11) from the spark
plug (31) by simultaneously pull-
ing and turning.
ter clockwise with a spark plug
socket.
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.75 mm.
carefully bending the ground
electrode on the spark plug.
brush.
spark plug or replace a dam-
aged spark plug with a new one
(recommended torque 20 Nm,
determined with a torque
wrench).
GB
89