Initial Operation
Caution! Risk of injury from rotat-
ing blades. Carry out work on the
equipment only when the blade is
switched off and stationary.
Before starting the equipment, you must
-
Remove the Protective Caps
-
Install the handle bar
-
Install the grass collection box
-
Install the starter cord
-
Fill with engine oil
-
Fill with petrol
-
adjust cutting height if required
Installing the Handle Bar
Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. Remove the two star grip
screws (20) from the machine
housing (16).
2. Attach the ends of the lower
handlebars (4) to the machine
housing (16).
3. Screw the two lower handlebars
(4) tight with the enclosed star
grip screws (20) on the right
and left of the mounting on the
machine housing (16).
4. Unfold upper handlebar (1) and
D
push locking lever (20) toward
bar.
5. Fix the Bowden cables (5a) to
the bar using the cable clamp
(5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket (19):
1. Loosen the Phillips screw (27a)
on the carrying handle (27).
2. Place the carrying handle (27)
on the upper side of the grass
collector (19) and screw it tight
with a Philips screw (27a) from
below.
3. Push basket rods (25) into bas-
ket net.
4. Pull plastic loops (26) over bas-
ket rods (25).
Fixing the Grass Collection
Box onto the Equipment:
5. Lift up shock protection (6).
6. Hook the grass collection box
(19) into the mounting provided
for this (28) on the rear of the
equipment.
7. Release the impact protection
(6). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
8. Lift the impact protection (6) and
remove the grass collection box
(19)
9. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
GB
85