INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will be
mounted.
2.
Carefully slide the shanks (2.1) on the faucet body (A) into the sink
holes. From underneath the sink, thread the mounting nuts (AA)
onto the shanks (2.1) on the faucet body (A). Check the position of
the faucet and hand tighten until the faucet body (A) is securely
mounted. NOTE: It is helpful to have a second person hold the
faucet in place while tightening the mounting nuts (AA).
Hardware Used
Mounting nut
AA
3.
Loosen the cover on the weight (B) and slide it onto the spray
hose (3.1) until it is positioned at the location marked "weight
here," then hand tighten the cover by turning it in a clockwise
direction. Confirm the O-ring at the end of the spray hose (3.1) is
positioned correctly. Attach the quick connector (3.2) by screwing
it onto the end of the spray hose (3.1). in a clockwise direction.
Hand tighten only.
4.
Push the quick connector (4.1) on the end of the spray hose (4.2)
into the quick connect coupling (4.3). Give the spray hose (4.2) a
gentle tug to ensure the coupling is connected. If it is necessary
to disconnect the spray hose (4.2) from the faucet (A), squeeze
the tabs on the side spray quick connect outlet (4.3) and pull
down on the quick connector (4.1) to disconnect.
5.
Attach one end of each of the water supply lines onto the
shanks (5.1) on the faucet body (A), with hot water on the left and
cold water on the right. Use 1/2 in. IPS faucet connections (5.2)
or supply line coupling nuts (5.3) with 3/8 in. OD ball-nose
risers (5.4). NOTE: Do not reuse existing supply lines. When
installing new water supply lines, please refer to the supply
line manufacturer's installation instructions.
Tighten the supply line connections using an adjustable or basin
wrench. Do not overtighten.
x 2
4
1
2
A
AA
AA
3
3.1
3.2
B
4
A
4.3
B
4.2
4.1
5
1
5.1
1
5.2
2.1
A
3
5.4
2
5.3