Emos E5111 Manual De Instrucciones página 5

Weather Station RESET
If the weather station displays incorrect values or does not respond to button presses, remove the
batteries and disconnect the power adapter, then reinsert the batteries and reconnect the adapter.
This will erase all data; you will need to set the weather station again.
The same method is used to reset the sensor.
Changing Sensor Channel and Connecting Additional Sensors
The station can be paired with up to 3 wireless sensors.
1. Long-press the CH button on the station; the
2. Remove the battery compartment cover on the back of the sensor and insert alkaline batteries
(2× 1.5 V AAA).
3. Set the sensor channel number (1, 2, 3) of your choice by repeatedly pressing the CH button.
The channel number will be displayed on the sensor's screen next to the humidity value. Data
from the sensor will be loaded into the station within 3 minutes. Repeat the whole process if
the sensor's signal is not detected.
Choose the sensor channel number (1, 2, or 3) by repeatedly pressing the CH button.
The number will be displayed on the station's screen in field no. 3.
Setting the Station to Display Data from Multiple Sensors
Press the CH button on the weather station repeatedly to view data from each connected sensor one by one.
Radio-Controlled Clock (DCF77)
After registering the wireless sensor, the weather station will automatically search for DCF77 signal
(hereinafter referred to as DCF) for 7 minutes; the icon will flash depending on the strength of DCF
signal. During the search, no other data on the screen will be updated and buttons will be disabled
(except SNOOZE/LIGHT).
Pressing the DOWN button for 3 seconds cancels the search for DCF signal.
Signal detected – the icon stops flashing and the current time and date will be displayed with the
Signal not detected – the DCF icon will not be displayed.
To repeat the search for DCF signal for 7 minutes, press and hold the DOWN button for 3 seconds. To
cancel the search for DCF signal, press and hold the DOWN button again for 3 seconds. DCF signal
will be synchronised regularly every day between 01:00 and 05:00.
During summer time, the
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes.
If the weather station does not detect the signal, follow these steps:
1. Move the weather station to another location and try to detect the DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). It should be at least 1.5 to 2 m during the reception of signal.
3. When receiving the DCF signal, do not place the weather station near metal doors, window
frames and other metal structures or objects (washing machines, dryers, refrigerators, etc.).
4. In reinforced concrete structures (cellars, high-rise buildings, etc.), the reception of DCF signal
is weaker, depending on the conditions. In extreme cases, place the weather station close to a
window in the direction of a transmitter.
The reception of the DCF radio signal is affected by the following factors:
• Thick walls and insulation, basements and cellars.
• Inadequate local geographical conditions (these are difficult to assess in advance).
• Atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
If the weather station cannot detect the DCF signal, time and date must be set manually.
Note: If the weather station detects the DCF signal but the current time on the screen is incorrect (e.g.
shifted ±1 hour), you must set the correct time zone for the country where you are using the station, see
Manual Setting of Time and Date. The current time will be shown with the appropriate time zone difference.
icon will start flashing.
icon will be displayed below the time value.
5
icon.