Replacing The Antenna; Maximizing The Distance; Attaching The Belt Clip - Dogtra Europe PATHFINDER Manual De Utilización

REPLACING THE ANTENNA

For the GPS Connector
1. Twist the antenna counter-clockwise to remove.
2. Place the new antenna on the bolt and turn clockwise to tighten the antenna.
For the Collar
Open the antenna enclosure by removing the 4 screws and the contact points.
Remove the screw holding the antenna in place to replace the antenna.
98

MAXIMIZING THE DISTANCE

• The PATHFINDER has a 10-kilometer line of sight range.
• To get the greatest range, hold the GPS Connector away from your body and
avoid touching the antenna.
• Keep your unit properly charged for maximum signal strength.
• The GPS Connector device must be near your phone for proper operation,
preferably less than 10 meters.
Maximum range Typical range

ATTACHING THE BELT CLIP

Follow the instructions below to attach the included belt clip to the GPS
Connector.
1) Align the belt clip to the grooves on the back of the GPS Connector.
2) With a firm grip, screw on the belt clip's Phillips head screws with
a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over tighten.
Minimum range
99