Publicidad
Idiomas disponibles
Idiomas disponibles
Should any liquid ingress into the housing of this equip-
ment, unplug the unit from the wall socket (if connected)
and have it checked by an authorised expert.
4.6. Electromagnetic interference
• Operation in close proximity (i.e. less than 2
metres) to working shortwave or microwave
therapy units may produce instability in the
Endomed 182 output.
• To prevent electromagnetic interference, we
strongly advise using separate mains groups
(phases) for the Endomed 182 and the shortwave
or microwave equipment, and a distance of at
least 2 metres is kept between the Endomed 182
and the shortwave or microwave equipment.
• Ensure that the mains cable of the shortwave/mi-
crowave unit does not come near the Endomed
182 or the patient.
If problems with electromagnetic interference per-
sist, please contact your authorised distributor.
5.1. Controls
(See jacket flap)
5.1.1.
Device
[1] On / off button
This button is to switch the unit on and off.
[2] Current form display
This display shows the current selection by LED.
To change the current form push button [16].
[3] Display for AMF and modulation frequency
(spectrum)
This display shows the readout from AMF or
modulation frequency. The display mode is
changeable with button [4]
[4] Selection button
With this button you change the read-out mode
in display [3] from AMF to Modulation frequency
[5] Adjust buttons for AMF and Modulation fre-
quency
Use this [-] / [+] buttons to adjust the AMF and
Modulation frequency.
[6] Display for timer and indicators for modula-
tion program
18
Read-outs display for timer and the indications
LED's for the modulation programs.
CHAPTER 5 - OPERATION
[7] Selection button for modulation program
Selection button for the modulation programs.
Selection will be indicate by LED in display [6]
[8] Adjust buttons for the treatment time
Use this [-] / [+] buttons to adjust the timer
[9] Display for intensity read-out in channel 1
Read-outs for intensity in channel 1, channel
selection and balance.
[10] Display for intensity read-out in channel 2
Read-outs for intensity in channel 2
[11] Selection button channel 1 or 2
This button is to select the channel for adjusting
the intensity with the buttons [13].
[12] Connector for patient cable.
Connection for the patient cable for both chan-
nels.
Connection of accessories other than ones
specified by the manufacturer can adversely af-
fect the safety of the patient and correct func-
tioning of the equipment, and is therefore not
permitted.
For combined applications use only Enraf-Non-
ius type BF equipment. The very low leakage
current of this type of equipment ensures abso-
lutely safe therapy.
[13] Adjusting buttons for the intensity and pre-
programmed protocols
Use this [+]/[-] buttons to adjust intensity and
program selector for the programs P0 until P30.
[14] Connector
Connect here the main adapter.
[15] Memory button
To activate the memory function, recall and store
button. Read-out is in display [9] en [10].
[16] Selection button Current forms
To select the current forms. The selection will be
displayed on display [2]
[17] Connection plug remote control
Connect here the optional remote control.
Connection of a remote control other than one
specified by the manufacturer can adversely
affect the safety of the patient and correct func-
tioning of the equipment, and is therefore not
permitted.
Publicidad
