Enraf Nonius Endomed 182 Instrucciones De Manejo página 23

5.2.2. Pre-programmed protocols selection
Enraf-Nonius stored parameters on the P1 until P30. The treatment suggestions are described on the therapy
card.
Switch on
• Connect the standard main adapter to connector [14]
• Connect the main adapter plug to the mains socket.
• Switch the unit on with the button [1]
During the start-up period runs a self-test.
• Connect the patient cable adapter on connector [12]
• Fix the electrodes to the patient.
Program selection
• Push the button [15]
• Select a program number(P 1 - P 30 ) with the buttons [13] read-out in display [9 +10]
• After the selection with the buttons [13] parameters will be displayed of the selected program.
Start the treatment
• The program will start after the adjusting of the intensity.
• The countdown starts.
Stop the treatment
Adjust the timer to zero or select a other current form
5.2.3. Programming
The program P0 can be programmed. This position is ideal toe store the most frequent used parameters.
When the unit start-up these parameters of program P0 will be displayed. The program number P1 – P30 can
be overwritten at the same way.
Switch on
Connect the standard main adapter to connector [14]
Connect the main adapter plug to the mains socket.
Switch the unit on with the button [1]
Program selection
• Push the button [15].
• Select a program number(P 1 - P 30) with the buttons [13] read-out in display [9 +10].
• After the selection with the buttons [13] parameters will be displayed of the selected program.
Treatment parameters: Adjusting or changing
• Adjust the parameters as decrypted under 9.1 Settings of the Endomed182" (follow the steps until
adjusting the intensity).
Storing
• Push at the program button [15] during minimal 3 seconds.
• The parameter will be stored under the selected program number. The storing will be confirmed by a
double beep.
20