Cleaning And Maintenance; Disposal And Recycling - EINHELL AQUINNA 36/30 Manual De Instrucciones

6.3 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.4 Battery capacity indicator (Fig. 3 / item
10)
Press the battery capacity indicator switch (11).
The battery capacity indicator (10) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.

7. Cleaning and maintenance

HAZARD!
Always take the batteries out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approximately two seconds. This should
resolve the majority of clogrelated problems.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
Anl_AQUINNA_USA_SPK7.indb 13 Anl_AQUINNA_USA_SPK7.indb 13
EN
•
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clogrelated problems.
7.2 Maintenance
The inside of the device does not contain any
parts requiring maintenance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 13 -
25.10.2022 09:54:00 25.10.2022 09:54:00