Publicidad
Idiomas disponibles
Idiomas disponibles
Verifying Parts
Check that you have the tools needed for the as-
sembly of the saw, as shown in Fig. 5.
Fig. 5
Fig. 6
Position
combination
square.
3/4" (19mm)
board with
straight
top edge
16099221PH GCM18V-12SD OSI 20220506.indd 17
Tools Needed For Assembly
Combination Square
Draw line.
Checking Combination Square
Check that the combination square is true.
1. Position the square and draw a light line as
shown in Fig. 6.
2. Flip the square as shown in Fig. 6.
3. Check the edge of the flipped square against
the drawn line, and make sure there is no
gap or overlap at the bottom end as shown
in Fig. 6.
Torx Wrench (43)
No gap or overlap.
-17-
(supplied)
Flip square here.
5/6/22 12:15 PM
Publicidad
