Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid possible injury, disconnect battery pack before performing any as-
sembly, adjustments or repairs.
Storing the Torx Wrench
There is a storage location on the saw to store
the Torx wrench (Fig. 7, 43). Insert the short leg
of the Torx wrench through the rubber grommet
as shown. Place the long leg into the tool rest.
NOTE: The
Torx wrench (43) is needed to
change the blade and to attach the side exten-
sions. If lost, use a Torx 30 wrench or a key.
Fig. 7
43
16099221PH GCM18V-12SD OSI 20220506.indd 18
Assembly
Attaching the Base Extensions
Attach each base extension to the left and right
side of the base:
1. Place the base extension (Fig. 8, 16) flush
against the base.
Fig. 8
16
Torx screws
2. Using the Torx wrench (Fig. 7, 43) and the
Torx screws provided (Fig. 8 and Fig. 9), at-
tach the base extension (16) to the base.
Fig. 9
16
3. Using the Torx wrench (Fig. 7, 43), tighten
both Torx screws until the base extension is
fully seated against the base. Then tighten
both Torx screws another 1/8 turn.
NOTE: To avoid overtightening and damaging
the threads of the Torx screws, tighten the Torx
screws by hand with the Torx wrench (43). Do
not use a power screwdriver or impact wrench
on the Torx screws.
-18-
Torx screws
5/6/22 12:15 PM
Publicidad
