General; Care And Maintenance; Specifications - Aiwa XC-37M Manual De Instrucciones

GENERAL

CARE AND MAINTENANCE

Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent solution.
Do not use strong solvents such as alcohol, benzine or thinner.
Care of discs
• Before playing a disc, wipe the disc from the center out with a
cleaning cloth.
• After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
9
ENGLISH

SPECIFICATIONS

Disc Compact disc
Scanning method Non-contact optical scanner
(semiconductor laser application)
Laser Semiconductor laser
(λ = 750 – 800 nm)
Rotation speed Approx. 500 rpm – 200 rpm (CLV)
Error correction Cross Interleave, Reed Solomon code
No. of channels 2 channels
D-A converter 1-bit dual
Wow/Flutter Unmeasurable
Signal to noise ratio 90 dB (1 kHz, 0 dB)
Harmonic distortion 0.05 % (1 kHz, 0 dB)
Low pass filter 8 times digital filter
Outputs
DIGITAL OUT (OPTICAL)
AUDIO OUT 2.0 V (47 k ohms)
PHONES(stereo) accepts headphones of 32 ohms or more
Power requirements 120 V AC, 60 Hz
Power consumption 12 W
Dimensions (W × H × D)
430 × 147 × 364 mm
Weight 5.3 kg
Accessories Remote control (1)
Audio connecting cord(1)
• Specifications and external appearance are subject to change
without notice.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against har mful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. lf this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- lncrease the separation between the equipment and
receiver.
- Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user's
right or authority to operate this product.