Recording; Ai Edit Recording - Aiwa XC-37M Manual De Instrucciones

RECORDING

AI EDIT RECORDING

The AI EDIT function lets you record tracks from one disc without
worrying about tape lengths and track lengths. When you insert
a CD, the unit automatically calculates track lengths. If necessary,
it rearranges the order of tracks, so that no track is cut short.
Use the remote control.
1 Prepare for recording.
2 Load the disc(s) onto the disc trays.
3 Press the DISC SKIP button to select a disc.
4 Press the AI EDIT button.
" " appears around AI and EDIT in the display.
5 Press the numbered buttons to designate the tape
length.
Enter a length from 10 to 99 minutes.
Example: when using a 60-minute tape, press the 6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
• The r and t buttons are also available to designate
the tape length.
Selected disc number
Total number of
programmed tracks
6 Select the proper function (CD or AUX) in the
stereo system.
7 Start recording.
Press the c/a button on the unit to start play and the button
for recording on the connected stereo system.
After play of programmed tracks on side A finishes, the unit
pauses. Reverse the cassette tape and start play and recording
again. Play of programmed tracks on side B starts.
7
ENGLISH
Programmed
tracks
Tape side
Time remaining on
the tape
To stop recording in the middle of the program
Press the s button on the cassette deck.
To clear the edit program
Before recording, press the s button twice so that "
around EDIT disappears.
To check the order of the programmed tracks
Before recording, press the AI EDIT button to select side A or B,
and press the PRGM/CHECK button repeatedly. The tracks in
the program are shown from the first track.
Track number
To delete a programmed track
Before recording, press the AI EDIT button to select side A or B,
and press the PRGM/CHECK button repeatedly to display the
track to be deleted, and then press the DELETE button on the
main unit.
To add tracks to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment before
recording starts.
1 Press the AI EDIT button to select side A or B.
2 Press one of the DISC 1-5 buttons to select a disc.
3 Press the numbered buttons to select tracks.
If the playing time of a selected track is longer than the
remaining time, it is not added.
4 Repeat steps 2 and 3 to add more tracks.
NOTE
• The AI edit recording cannot be used with discs containing
31 tracks or more.
• When tracks are added or deleted, the AI edit mode will change
to programmed edit mode automatically.
In this case, use the PRGM EDIT button to select side A or B
instead of AI EDIT button.
"
Program number