Publicidad
Idiomas disponibles
Idiomas disponibles
Drilling with a drill stand
Drill stand fixation
CAUTION
The drill stand must always be mounted firmly
and must not be able to move during drilling.
Aligning the drill stand
Set up the drill stand at the drilling location.
■
Rotate the centering plate 28 forwards, until it
■
snaps in.
Align the drill stand in such a manner that for
■
the used machine the tip of the centering plate is
located directly above the required drilling location.
Fasten the drill stand.
■
Secure using assembly
Drill the rawlplug hole Ø 16 mm for rawlplug
■
W-ED M12.
Insert rawlplug.
■
Screw in assembly 30.
■
Align the drill stand.
■
Fasten the drill stand with the spindle nut 29.
■
Vacuum pump fixation
WARNING
Maximum drilling diameter of 100 mm.
Mount the drill stand on an even, firm and
smooth surface using the vacuum pump,
never "over" head.
Always connect the core drill and the vacuum pump
to the same power outlet. Never turn off the vacuum
pump during operation.
Position the machine horizontally. Maximum tilt of 10°.
■
Fasten, mount suction hose and fasten with hose
■
clip. Fasten the drill stand.
See further the vacuum pump manual.
Mounting the drill bit 31
Tighten the clamping lever 24.
■
Clean and grease the thread on the drill bit 31
■
and the tool holding fixture 5.
Screw a core bit 31 onto the tool holder 5 and
■
tighten with supplied wrenches.
Connecting the water feed
Close the water tap 6.
■
Connect the water feed hose to the water tap or
■
the water pressure tank.
When using the water pressure tank, make sure
■
that there is sufficient pressure when working.
Check the water flow indicator 9.
■
16
Setting the drilling angle
Loosen the clamping lever 21.
■
Use handle 23 to slide the column into the
■
desired drill angle using the scale.
Tighten the clamping lever 21.
■
Drilling
Always ensure a adequate anchorage in the
■
underground.
Open the water tap 6.
■
Loosen clamping lever 24 and hold the feed
■
lever 20.
Actuate the ON/OFF switch 2.
■
You can use the soft starter 3 at drilling start.
■
Drill using an even forward feed. Do not over-
load the machine.
The leaking water should be milky and not clear.
■
Always loosen the clamping lever 24 when
■
drilling.
After drilling switch off the machine and shut
■
off the water tap. Lift the machine with feed
lever 20 and secure with clamping lever 24.
Removing the drilling core
Break off the drilling core and remove.
■
Over head drilling
DANGER
When drilling "over" head always secure
the drill stand with the assembly.
DANGER
When drilling "over" head, always use a
water collecting ring and a Würth indus-
trial wet-type vacuum cleaner!
Mounting the water collecting ring 15
Loosen the fixation screw 14 on the water col-
■
lecting ring 15.
Push the water collecting ring 15 onto the drill
■
stand and press it firmly against the material to
be drilled.
Tighten fixation screw 14.
■
Connect a Würth industrial wet-type vacuum
■
cleaner.
Attach a protective cover 13 onto the water col-
■
lecting ring and drill through. Remove the drilled
part of the cover from the core bit.
Publicidad
