How To Change The Bag; Liquids Vacuuming; At The End Of A Cleaning Session - Nilfisk cfm S2 Manual De Instrucciones

How to change the bag

WARNING!
■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■ Take care not to raise dust during these
operations. Wear a protective mask.
■ In case of dangerous and/or toxic dust, you must
use the supplied safety bag for these certified
vacuum cleaners.
■ The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
02/2013

Liquids vacuuming

WARNING!
Make sure that the vacuum cleaner is equipped with a
liquid level sensor and is suitable for vacuum liquids.
■ The filter element will be wet after liquids have been
vacuumed.
A wet filter element can quickly become clogged if the vacuum
cleaner is then used to vacuum dry substances.
For this reason, make sure that the filter element is dry or
replace it with another one before using the vacuum
cleaner for dry materials.

At the end of a cleaning session

■ Turn the vacuum cleaner off and disconnect the plug
from the socket.
■ Wind the connection cable up and hang it in the relevant
compartment (Fig. 13).
■ Empty the container as described in the "Emptying the
container" paragraph.
■ Clean the vacuum cleaner as described in the paragraph
"Maintenance, cleaning and decontamination".
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized persons.
9
S2 / S3
US
C344