Publicidad
Idiomas disponibles
Idiomas disponibles
7. Pull the PTO switch to start the mower cutting blades and adjust the blade speed to the highest. Refer to
section"Blade-Speed Adjustment Button" in this manual.
8. Flush water under the deck for approximately one minute.
9. Turn off the blade motors by pushing the PTO switch downward.
10. Turn off the water and remove garden hose and quick-coupler from wash port.
11. Remove the quick-coupler from the garden hose and store it in a safe location for future use.
12. Turn off the mower completely. See section "STOPPING THE ELECTRIC ZERO TURN MOWER".
NOTE: When cleaning the deck using the wash port, the mower can be either in mulching or side discharging mode.
NOTE: If the mower is not clean after one wash cycle, repeat the process until the deck is thoroughly cleaned.
LEVELING THE MOWER DECK
WARNING: Always protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other
materials when performing any maintenance on the mower blade.
◾
If your lawn appears unevenly cut after using the mower or when the mower blade is reinstalled, the mower deck
may need adjusting.
◾
Before deciding that leveling the mower deck is necessary, make sure that the tires are properly inflated to the
recommended pressure (Please see section "CHECKING THE TIRE PRESSURE" in this manual). Over- or under-
inflated tires can affect the appearance of the cut grass, and proper inflation of the tires may be all that is needed to
resolve uneven cut issues. If the tires are under or over-inflated, the deck cannot be correctly adjusted.
◾
Check bent blades prior to leveling. Remove and replace any bent blades. See section "REPLACING THE CUTTING
BLADES" in this manual for reference.
◾
Adjust the deck while the mower is on a level surface. Raise the deck to the highest position.
NOTE: Mower deck anti-scalp wheels should not contact the ground when leveling the deck.
NOTE: The deck must be adjusted slightly higher in the rear.
Required tools (not supplied): one 13/16" (21 mm) open-end wrench, one 23/32" (18 mm) open-end wrench or
adjustable wrench; one leveling gauge.
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC
51
Publicidad
