Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the water collecting
ring 34
Loosen the fixation screw 33 on the water collecting
■
ring 34.
Push the water collecting ring 34 onto the drill stand
■
and press it firmly against the material to be drilled.
Tighten fixation screw 33.
■
Connect a Würth industrial wet-type vacuum cleaner.
■
Mounting the drill bit 31
Tighten the locking screw 16.
■
Clean and grease the thread on the drill bit 31 and
■
the tool holding fixture 6.
Screw a core bit 31 onto the tool holder 6 and
■
tighten.
Loosen the locking screw 16.
■
When using the water collecting ring, attach a pro-
■
tective cover 32 onto it and drill through. Remove te
drilled part of the cover 32 from the core bit.
Connecting the water feed
Close the water tap 7.
■
Connect the water feed hose to the water tap or the
■
water pressure tank.
When using the water pressure tank, make sure that
■
there is sufficient pressure when working.
Check the water flow indicator 3.
■
Setting the drilling angle
Loosen the clamping lever 17.
■
Push in or pull out the rod 15 until the desired
■
drilling angle is shown on the scale.
Tighten the clamping lever 17.
■
Hand held drilling
WARNING
Hand held drilling only for DS 130-P/-T.
Maximum bit diameters:
• Wet drilling in concrete: Ø 40 mm.
• Dry drilling in brick, masonry: Ø 162 mm.
Hand held wet drilling
For wet drilling open the water valve 7 and switch
■
on the machine 2.
Hold the machine as rigidly as possible.
■
Always use the grip 5 at the front of the machine.
■
Start drilling by keeping the machine at a slight angle.
■
After the bit is guiding itself into the material, swivel
■
back the machine into the right angle position.
18
Hand held dry drilling
For dry drilling install the dry drilling kit 10.
■
Drilling is only possible if the masonry is absolutely
■
dry. Use a powerful industrial dust exhauster.
Change the filter regularly, there is risk of obstruc-
tion.
Hold the machine as rigidly as possible.
■
Always use the grip 5 at the front of the machine.
■
Start drilling by keeping the machine at a slight
■
angle.
After the bit is guiding itself into the material, swivel
■
19 back the machine into the right angle position.
WARNING
The machine has a very high torque,
especially in the first gear. Therefor drill
only extremely concentrated, especially
when working in first gear and with
diameters of more than 60 mm.
In case of sudden blocking of the core bit the
machine, despite the safety clutch, might get out of
control and hurt you considerably.
Drilling with a drill stand
Always ensure a adequate anchorage in the
■
underground.
Open the water tap 7.
■
Actuate the ON/OFF switch 2.
■
Drill using an even forward feed. Do not overload
■
the machine.
The leaking water should be milky and not clear.
■
Always loosen the locking screw 16 when drilling.
■
After drilling switch the machine off and shut off the
■
water tap.
Removing the drilling core
Break off the drilling core and remove.
■
Transport and Storage
CAUTION
Danger of injury and damage!
Pay attention to the weight of the appli-
ance when transporting it.
Clean the machine and remove the drilling dirt.
■
Transport the machine and core bit separately.
■
Blow out remaining water from hose and machine
■
when it freezes.
This appliance may only be stored inside a building.
■
Publicidad
