Publicidad
Idiomas disponibles
Idiomas disponibles
position (fig 3).
5 Give a gentle push on the primer pump
(2) repeatedly (7 to 10 times) until fuel
comes into the primer pump.
6 Move the choke lever (3) to position
→open.
7 Hold the unit down firmly so you will not
lose control while cranking the engine. If
not held down properly, the engine could
pull you off balance or swing the cutting
blade into an obstruction or your body.
8 Slowly pull the starter grip until
resistance is felt and continue with smart
pull until initial ignition is heard.
9 Depress the choke lever (3) to the position close← and pull the starter rope again
until the engine starts.
10 As soon as the engine starts, immediately tap and release the throttle ，thus
releasing the half-throttle rock so that the engine can run in idle.
11 Run the engine for approximately one minute at a moderate speed before applying
full speed.
Hot starting： (Restarting immediately after
the engine has stopped)
When restarting a hot engine ， first try the
above procedure：1，7，8
If the engine does not start，repeat above steps
1-11.
Note： Do not pull the starter rope to its full
extent and do not allow the starter grip to be
retracted without control， ensure that it is
retracted slowly.
STOPPING THE MACHINE
1. Release the throttle lever completely.
2. Push the 1-O switch (on/off switch) to "O" position，the engine rotation will before
low and the engine will stop.
Publicidad
