Flotec FP0S4100X Manual Del Usuario página 5

Installation
Pumps include the adapters below.
1", 3/4" or
1/2" Barbed
Hose Adapter
1-1/4"x1" NPT
Adapter
1" NPT" to
Garden Hose
Adapter
1-1/4"x1" NPT
Adapter
Figure 2: Typical Installation Setup. Models FP0S1200X,
FP0S2300X, and FP0S3000X include 3 adapters shown.
Model FP0S4100X includes 1-1/4" x 1" NPT adapter
only.
For parts or assistance, call Flotec Customer Service at
OPERATION
cause death. Do not handle a pump or pump motor with
wet hands or when standing on a wet or damp surface, or
in water.
1. Shaft seal depends on water for lubrication. Do not
Model Numbers
FPOS1200X,
FPOS2300X
FPOS3000X
Include three
2. The motor is equipped with an automatic reset ther-
different adapters
FPOS4100X
Includes one
adapter
3. The pump will not remove all water. If the pump is
3384 0399 B
4. This pump is designed to pump cold water only.
5. Pump can run in water that doesn't completely cover
6. Keep the inlet screen clean at all times. If the bottom
7. If you need to reduce the flow, restrict the discharge.
Hazardous voltage. Can shock, burn or
operate the pump unless it is in water as the seal may
be damaged if allowed to run dry.
mal protector. If the temperature in the motor should
rise unduly, the switch will cut off all power before
damage can be done to the motor. When the motor
has cooled sufficiently, the switch will reset automati-
cally and restart the motor. If the protector trips
repeatedly, remove the pump and check it as to the
cause of difficulty. Low voltage, long extension cords,
clogged impeller, very low head or lift, etc., could
cause cycling.
operating and suddenly no water comes out of the
discharge hose, shut off the unit immediately. The
water level is probably very low and the unit has bro-
ken prime.
NOTICE: For continuous operation, water must flow
through pump to prevent motor overheating. The
pump is cooled by the water flow through the housing.
Pumping heated liquids can overheat the motor and
cause the thermal overload to trip.
the motor housing, but the inlet must be completely
submerged or it will break suction and will not move
any water.
surface of the pond or waterfall is dirty, raise the
pump slightly to reduce the amount of debris pulled
into the pump inlet.
Do not restrict the intake. Doing so will starve the
pump for water and can cause overheating.
1-800-365-6832
5