Sage the Barista Express BES875 Guía Rápida página 10

Trimming the Dose
The Razor precision dose trimming tool
™
allows you to trim the puck to the right level
for a consistent extraction.
• Insert the Razor dose trimming tool into the
™
filter basket until the shoulders of the tool rest
on the rim of the basket.
• Rotate the Razor
™
and forth while holding the portafilter on an
angle over a knock box to trim off excess
coffee grinds.
Purging the Group Head
Before placing the portafilter into the group
head, run a short flow of water through the
group head by pressing the 1 CUP button
approximately 5 seconds to get rid of the left
over grind and stabilize the temperature.
Inserting the Portafilter
WARNING
DO NOT insert the portafilter with the dosing
funnel in the group-head.
Insert the portafilter into the group head and
rotate the handle towards the centre until
resistance is felt.
10
dose trimming tool back
Preset Shot Volume – 1 CUP button
Press the 1 CUP button once to extract
a single shot of espresso at the preset volume
(approx. 30ml).
NOTE
Pressing the 1 CUP or 2 CUP button during
a preset shot volume will immediately stop
the extraction.
Preset Shot Volume – 2 CUP button
Press the 2 CUP button once to extract
a double shot of espresso at the preset volume
(approx. 60ml).
Re-Programming
Shot Volume – 1 CUP or 2 Cup
1. To begin programming, press the Programme
button once.
2. Press 1 CUP or 2 CUP button to start espresso
extraction. Press 1 CUP or 2 CUP button
again once desired volume of espresso has
been extracted. The machine will beep twice
to indicate the new 1 CUP or 2 CUP volume
has been set.
Resetting Default Volumes
To reset the machine to the default 1 CUP
and 2 CUP shot volumes, press and hold the
PROGRAMME button until the machine beeps
three times. Release the PROGRAMME button.
NOTE
Default settings: 1 CUP shot volume is approx.
30ml. 2 CUP shot volume is approx. 60ml.