Technical Data; Limited Warranty - GreenWorks LMA145 Manual Del Operador

Problem Possible cause
The machine The extension
does not start. cable is not con-
nected to the
outlet.
The extension
cable is not con-
nected to the
power supply.
The bail switch is
defective.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high The blade is un-
vibration in the balanced and
machine. worn.
The engine shaft
is bent.
English
Solution Problem
Reconnect the The machine
cable. stops during
mowing.
Connect the ex-
tension cable to
a live 120V AC,
60 HZ AC recep-
tacle.
Replace the bail
switch.
* If you cannot find the solution to these problems, go to
Examine the
the service center.
mowing area.
Move the wheels
10
to a higher posi-
tion.
Motor
Wait until the
No load speed
grass dries be-
fore mowing.
Height adjustments
Install the mulch
plug.
Functions
Increase the
blade height.
Weight
Empty the grass
Double-insulated con-
clippings from
struction
the grass catch-
er.
11
Replace the
blade.
1. Stop the en-
gine.
YEAR/ANS/AÑOS
TOOL WARRANTY
2. Disconnect
the power
supply.
3. Inspect for
Greenworks
damage.
original purchaser with proof of purchase, for a period of
4. Repair the
four (4) years against defects in materials, parts or
machine be-
workmanship. Greenworks
fore you start
repair or replace any and all parts found to be defective,
it again.
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use that have not been hired or
rented for industrial/commercial use, and that have
been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
9
Possible cause
The blade height
is too low.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.

TECHNICAL DATA

120 V AC, 60 Hz, 13 A
3500 RPM
1 3/8 - 3 3/4" (3.5 - 9.5
cm)
3-in-1: Mulching & Rear
Bagging & Side Discharge
Capabilities
24.8 kg (55 lbs.)

LIMITED WARRANTY

GARANTIE DE
L'OUTIL
HERRAMIENTA
®
hereby warranties this product, to the
®
, at its own discretion will
EN
Solution
Increase the
blade height.
Disconnect the
power supply
and check the
deck.
Cool the ma-
chine.