Publicidad
Idiomas disponibles
Idiomas disponibles
Usage
We advise that you allow your freezer to stand for a minimum of 3 hours before
plugging it into the mains.
The temperature in the appliance is controlled by the temperature control dial or
thermostat located inside the freezer. Rotate the control dial left or right to
regulate the temperature inside the freezer.
On the temperature control, 1 is the warmest setting and 7 is the coldest setting.
Depending on the ambient temperature of the room the appliance is situated in,
you may need to adjust the temperature control dial; in a room with a high
ambient temperature the temperature control dial may need to be adjusted to a
colder setting (moved towards setting 6) or in a room with a low ambient
temperature the temperature control dial may need to be adjusted to a warmer
setting (moved towards settings 5 or 4).
Setting 6 should be used as a rapid cool/freeze setting and should only be set 2
hours before a large amount of food is placed in the freezer. The temperature
control should be put back to setting 5 after the food has been placed in the
freezer, if this is not done the temperature in the freezer compartment could fall
below -18ºC as the compressor will run continuously.
Once the temperature control has been set, close the door and plug in the
appliance. We recommend that the door is not opened for a minimum of 4
hours to allow the appliance to reach the standard operating temperature.
8
Publicidad
