Introduction; Description; Features; Definition Of Signal Warnings And Symbols - OHAUS Frontier FC5706 Manual De Instrucciones

TM
Frontier Centrifuge FC5706

1. INTRODUCTION

1.1 Description

Thank you for choosing this OHAUS product.
All symbols indicate safety instructions and points to potential dangerous situations. Please read the manual
completely before using the Frontier
TM
Frontier 5706 centrifuge was designed for the separation of materials or mixtures with different density.
1.2

Features

TM
The Frontier FC5706 centrifuge offers many practical features such as:

Distinct control panel

Simple one-handed operation

Set and view speed in both rpm and g-force

Control all settings with ergonomic adjustment knob

Accommodate all tube sizes

1.5ml,2.0ml,5ml,7ml,15ml,16ml,30ml,50ml

No tool needed to install or uninstall rotors
1.3

Definition of Signal Warnings and Symbols

Safety notes are marked with signal words and warning symbols. These show safety issues and warnings.
Ignoring the safety notes may lead to personal injury, damage to the instrument, malfunctions and false results.
The degree of danger is a part of a safety note and distinguishes the possible results of non-observance from
each other.
Signal Words
DANGER
WARNING
CAUTION
ATTENTION
NOTE
Warning Symbols
General Hazard
Alternating Current
Explosion
Warning and information signs on the surface of centrifuge
TM
FC5706 to avoid incorrect operation.
Will lead to severe injuries or death if not avoided.
For a hazardous situation with medium risk, possibly resulting in injuries or
death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or
the property or in loss of data, or injuries if not avoided.
For important information about the product. May lead to equipment damage if not
avoided
For useful information about the product
Four carrier must be used at all times on four place swing out rotors or damage
will occur to the centrifuge. Such damage will not be covered under the product
warranty.
Attention! Check the fastening of the rotor nut before each run.
Take off mains plug before opening the housing or the emergency release.
Electrical Shock Hazard
Biohazard
Crushing
EN-1