Publicidad
Idiomas disponibles
Idiomas disponibles
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver
into the hole on the side. Insert a 3 V battery, type CR2032,
into the button. When inserting a battery, make sure it has the
correct polarity!
2. Plug the chime into a socket and long-press the pairing button
on the chime for ca 5 seconds.
3. The chime will ring 2 times and will automatically switch to
self-learning mode for 30 seconds. Press the ring button within
30 seconds. The chime will ring once again. The button is now
paired with the chime.
4. Re-assemble the button.
5. To pair multiple buttons, repeat the procedure for each button
from step 1.
Note: The chime has an internal memory where it stores the codes
of the currently paired buttons for the event of a power failure. There
is thus no need to pair buttons again after a power cut.
Wiping the Memory of Paired Buttons
1. Long-press the pairing button on the chime for ca 10 seconds.
2. The chime will ring 3 times and the memory of ALL paired
buttons will be erased.
Ringtone Selection
1. Repeatedly press the ringtone change button located on the
chime.
2. Each press of the button will play a different ringtone. The last
ringtone played is the one that will be used.
Note: If you erase the memory of paired buttons, the set ringtone
will also be reset to default.
Setting the Bell Volume
1. Repeatedly press the volume setting button located on the
chime.
2. You can set 4 volume levels (25 % – 50 % – 75 % – 100 %).
Installation of the Doorchime (Transmitter) Button
1. Begin by pairing the button with the chime.
4
Publicidad
