Descargar Imprimir esta página

Ega Master 59127 Manual De Instrucciones página 26

Publicidad

Idiomas disponibles

Idiomas disponibles

BATTERY PACK PREPARATION FOR RECYCLING
WARNING: Upon removal, cover the battery pack's terminals with heavy duty
adhesive tape. Do not attempt to destroy or dis- as-semble the battery pack or remove any of
its components. Do not touch both terminals with metal objects and body parts, as short- circuit
may result. Keep away from children. Failure to comply with these warnings could result in fire
and/or serious injury.
This product contains Lithium Ion batteries which must be disposed of properly.
1. Be aware that this tool is always in an operating condition, because it does not have to be
plugged into an electrical outlet.
2. Fully charge the battery for better operation.
3. Be sure the battery is snapped in place.
4. When not in use, lock the switch.
5. When operating at a high place, be aware of things below and around you.
6. Before drilling into walls, ceilings, or floors, ensure that there are no concealed power cables
inside.
7. This unit features the overload protection design. When the unit overload or stall, the power
would be cut-off automatically. This will protect the motor, switch and battery.
8. This unit features a battery temperature detective sensor. If the battery exceeds the safety
working temperature, the unit would shut-off automatically. Once the temperature dropped
back to the safe temperature zone, the unit would function normally again.
9. This unit features a battery over-discharge protection system which can prolong the battery's
lifespan.
Model
Chuck Capacity
Motor
Max. torque
Toque clutch adjustment
Action adjustment mode
Blow per minute
Drill capacity
Net weight (w/o battery)
26
SPECIFICATIONS
18V No Load Speed
Speed adjustment range
125 Nm (1,275 kgf-cm)
21 (Screwdriver)
0~30,000 BPM Drill capacity
in wood: 38mm
in steel: 13mm
in Masonry: 13mm
59127
1/2" (13mm)
High: 0~2,000/min.
Low: 0~500/min.
High: 600~2,000/min.
(Speed adjustment is 100
rpm)
Low: 250~500/min.
(Speed adjustment is 25 rpm)
Hammer mode
Screwdriver mode
Drill mode
1.66 kg

Publicidad

loading

Este manual también es adecuado para:

59129