Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGER LED INDICATION
CHARGER
STANDBY
WHILE
CHARGING
CHARGING
COMPLETE
MALFUNCTION
BATTERY
NOTE: The battery will not reach full charge after the first charge. Allow several cycles
(drilling followed by recharging) for them to become fully charged.
INSTALLING AND REMOVING THE AUXILIARY HANDLE
1. When installing the handle bar into the tool assembly, please make sure that it's place
in the design slotted area. After the handle bar set is in position, please turn the handle bar set
clock-wise to tighten and counter clock-wise to loosen the handle bar set. Please make sure
that the handle bar set is properly secured before operation. (Fig. 4)
2. If you need to use the handle bar set, you can rotate the handle bar set to your desire
location to improve safety and comfort.
INSTALLING AND REMOVING BITS
WARNING: Before installing or removing bits, place the direction of rotation in center
position. This will turn off the power to your drill.
Push in the drill bit as far as possible. Turn the sleeve in the rotation "Grip" until you hear
a click. The drill bit is not sufficiently firmly chucked after you have continued turning applying
some considerable force-until it any more. (Fig. 5)
30
Red light
steady on
Red and green
light steady on
Red light blinking
Red light steady on
green light blinking
Red and Green
lights blink
alternately
Fig.4
Stand by
Charging
Battery too hot
Battery too cold
Full charged
Replace the
battery
Auxiliary Handle
LOCK
LOOSE
Publicidad
