Publicidad
Idiomas disponibles
Idiomas disponibles
Re-chucking maybe necessary if the drill bit shank is rather soft.
INSTALLING AND REMOVING THE BELT HOOK
CAUTION: When installing the hook, tighten the screw firmly. Failure to do so may
cause the breakage of the tool or personal injury.
1. The belt hook is convenient for temporarily hanging the tool. This can be installed on either
side of the tool.
2. To install the belt hook, insert it into a groove in the tool housing on either side and then
secure it with a screw. To remove, loosen the screw and then take it out. (Fig. 6A & Fig. 6B)
3. After installing the belt hook, make sure that it is screwed firmly.
SPINDLE LOCK
WARNING: Excessive tightening by hand may damage the screw.
The automatic spindle lock enable bits to be changed quickly and easily in the keyless
chuck.
The drill spindle id locked when the switch is not pressed or when it is released, so that
projecting screws can be screwed in flush by manually rotating the machine.
WARNING: Before installing or removing bits, place the direction of rotation in center
position. This will turn off the power to your drill.
Fig.6A
Fig.5
Fig.6B
31
Publicidad
