Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Use the reversing switch only after the tool comes to a complete stop.
Changing the direction of rotation before the tool stops may damage the tool. When not
operating the tool, always set the reversing switch lever to the neutral position.
TRIGGER
1. To start the tool, simply press the trigger. Tool speed is increased by increasing pressure on
the trigger. Release the trigger to stop. (Fig. 8)
2. When the trigger is depressed the chuck will rotate (provided the forward/reverse level is set
in the forward or reverse position). The trigger can be locked in the OFF position. This helps
reduce the possibility of accidental starting when not in use. To lock trigger, place selection
lever in the centre position.
TWO-SPEED LEVEL
CAUTION: Never change gears while the tool is running. Failure to obey this caution
could result in serious damage the drill
The drill has a two-speed level designed for drilling or driving at "High (1)" or "Low (2)"
speeds.
A slide level is located on top of the drill to select either "High (1)" or "Low (2)" speed. When
using drill in the "Low (2)" speed range, speed will decrease and unit will have more power and
torque. When using drill in the "High (1)" speed range, speed will increase and unit will have
less power and torque. Use "Low (2)" peed for high power and torque applications and "High
(1)" speed for fast drilling or driving applications. (Fig. 9)
Trigger
Fig.8
Two-speed level
Fig.9
33
Publicidad
