Publicidad
Idiomas disponibles
Idiomas disponibles
LED LIGHT
WARNING: Don't stare at the LED light, nor put the light illuminates people eyes. If eyes
focus on the light for a while, may cause pains.
1. Equipped with a LED light indicated the front of bits.
2. Light can be on with slightly pressing the trigger. (Fig. 10A)
3. To keep the LED light steady, press the middle button (A). The LED will automatically turn off
15 seconds after the tool is stopped. (Fig. 10B)
LED light
SPEED FUNCTION SELECTION
1. Speed "▲" button and speed "▼" Button is used to adjust the motor speed (RPM), which
can be applied to different applications, motor speed (RPM) will be wrong due to battery or
workload, and the value will be lower than the set value.
NOTE! The speed cannot be switched while the tool is running.
2. Before selecting the speed you need, please press the switch trigger to start the tool power.
3. Press the speed "▲" button (A), the speed will increase, press the speed "▼" Button (B), the
speed is reduced, positive and negative / high and low speed independent adjustment, The
speed adjustment is 100 RPM, and the speed adjustment of the low speed is once by 25
RPM. (Fig. 11)
34
Fig.10A
Fig.10B
Fig.11
Publicidad
