EGAmaster 59126 Manual De Instrucciones página 24

2. Always switch off the tool before installing or removing of the battery pack.
3. To remove battery pack, press the battery clip, and pull out. To install the battery pack, align
the tongue on the battery pack with the groove in the housing and slip it into place. Always
insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of
the tool, causing injury to you or someone around you.(Fig.1)
NOTE: Do not use force when installing the battery pack. If the cartridge does.
CHARGING THE BATTERY PACK
DANGER: If battery pack case is cracked or damaged, do not insert into charger.
Danger of electric shock or electrocution.
1. The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
2. Charge battery pack only with the charger provided.
3. Using an other charger can cause severe damage or even cause battery to explode from the
work piece and determine the reason for jamming.
4. Connect the charger to a power outlet. Place the battery pack in the charger aligning raised
rib on the battery pack with the groove in the charger.(Fig.2)
24
Fig.1
Cracked
Green
Light
Red
Light
Fig.2