EGAmaster 59126 Manual De Instrucciones página 29

CAUTION: When installing the hook, tighten the screw firmly. Failure to do so may
cause the breakage of the toolor personal injury.
1. The belt hook is convenient for temporarily hanging the tool. This can be installed on either
side of the tool.
2. To install the belt hook, insert it into a groove in the tool housing on either side and then
secure it with a screw. To remove, loosen the screw and then take it out.(Fig.8A & Fig.8B)
3. After installing the belt hook, make sure that it is screwed firmly.
NOTE: Always be sure that the tools is switched off and the battery pack is removed
before installing or removing the socket.
1. Always use the correct size socket for bolts and nuts. An incorrect size socket will result in
inaccurate and inconsistent fastening torque and/or damage to the bolt or nut.
2. To attach a socket, align the accessory with the anvil and push it firmly over the retaining
ring.(Fig.9A)
3. To remove the socket, pull the socket off the anvil.(Fig.9B)
BELT HOOK
Fig.8A
INSTALLING AND REMOVING SOCKET
Fig.9A
Fig.8B
Fig.9B
29