EGAmaster 59126 Manual De Instrucciones página 26

NOTE:
• The indicated capacity may be lower than the actual lever during use of the tool.
• Depending on the conditions of use and the ambient temperature, the indication may differ
slightly from the actual capacity
CHARGER
STANDBY
WHILE
CHARGING
CHARGING
COMPLETE
MALFUNCTION
BATTERY
NOTE:
The battery will not reach full charge after the first charge. Allow several cycles (drilling
followed by recharging) for them to become fully charged.
WARNING: Always check the direction of rotation before operation.
This determines the direction of rotation of the chuck, ie. clockwise or anti-clockwise.
To alter the direction of rotation stop the drill then push the selection lever to the left of right.
When the lever is in the "Forward" position the chuck will rotate clockwise. When the lever is in
the "Reverse" position the chuck will rotate anti-clockwise. Before operation check that the lever
is set in the required position.(Fig.4)
26
Lighted
CHARGER LED INDICATION
Red light steady on
Red and green light
steady on
Red light blinking
Red light steady on
green light blinking
Red and Green lights
blink alternately
FORWARD/REVERSE LEVER
Blinking
Charge the Malfunction
battery
Battery too hot
Battery too cold
Full charged
Replace the battery
Stand by
Charging