Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Use the reversing switch only after the tool comes to a complete stop.
Changing the direction of rotation before the tool stops may damage the tool. When not
operating the tool, always set the reversing switch lever to the neutral position.
1. To start the tool, simply press the trigger. Tool speed is increased by increasing pressure on
the trigger. Release the trigger to stop.(Fig.5)
2. When the trigger is depressed the chuck will rotate (provided the forward/ reverse lever is
set in the forward or reverse position).The trigger can be locked in the OFF position. This
helps reduce the possibility of accidental starting when not in use. To lock trigger, place
selection lever in the centre position.
HOW TO OPERATE THE IMPACT POWER SELECTION
1. The impact power selection button is used to adjust the torque, rotation speed (RPM), and
impact speed (IPM) for different application. Please pay attention. Power modes are not able
to be switched when tool being run.
2. Before you selecting the mode on the top pad, please click out the trigger to let electric
current through the pad for your selection.
3. L/M/H three modes only be selected at forward rotation, L/M/H three modes and mode (R
mode) are selected at reversed rotation. When the letter you press is lighted, the tool is
ready to work.(Fig.6A)
4. The lighted alphabetic symbols during operation are shown as battery capacity the tool
remains.The lighted alphabetic when trigger released is shown what speed mode the tool stays.
5. When 4 lights flash at once it symbols either the tool or the battery failed. Please check
carefully.(Fig.6B)
Forward
Fig.4
TRIGGER
Trigger
Fig.5
Reverse
27
Publicidad
