Safety Precautions; Display And Controls - OHAUS STARTER 300C Manual De Instrucciones

EN-2
1.2

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this
equipment. Failure to comply with these warnings could result in personal injury and/or property
damage. Retain all instructions for future reference.
Use the equipment only in dry locations.
Dry off any liquid spills immediately. The instrument is not watertight.
When using chemicals and solvents, comply with the instructions of the chemical producer
and the general lab safety rules.
Use only approved accessories and peripherals.
Operate the equipment only under ambient conditions specified in these instructions.
Do not operate the equipment in hazardous or unstable environments.
Service should only be performed by authorized personnel.
1.3

Display and controls

Displays
1
Endpoint stability icon
2
Measurement icon -
3
Calibration icon -
4
Setup icon -
5 Battery status icon shows the condition of the batteries - fully charged, half-charged or fully
discharged
6 TDS factor in the setup mode
7 Conductivity / TDS / Cell Constant
8 Standard
9 Temperature during measurement or reference temperature in setup mode
Find Quality Products Online at:
STARTER 300C Portable Conductivity Meter
1
6
7
8
; Auto endpoint icon
; measurement or calibration is running
; calibration in progress
; instrument is in the setup mode
/ Memory number / Error index
GlobalTestSupply
www.
2 3 4 5
9
.com
sales@GlobalTestSupply.com