Note
If the battery voltage in the screen display drops to one bar, a
warning sound is emitted every 2 minutes. In this case, you must
charge the battery.
Note
After a certain time (battery voltage), switch off the sweeping ag-
gregates and charge the battery urgently.
Sweeping with roller brush and side brush
Accelerator
1
Side brush foot pedal (lower/raise)
2
Wet sweeping flap
3
Ignition key
4
Manual filter cleaner
5
Selector switch for direction of travel
6
Twist knob for side brush speed
7
Roller brush foot pedal (lower/raise)
8
Coarse dirt flap
9
1. For cleaning work, select the forwards direction of travel.
2. Lower the roller brush by pushing the foot pedal inwards. The
roller brush and the suction fan start up.
3. For wet or damp surfaces, open the wet sweeping flap.
4. For cleaning near to edges, lower the side brush. To do so,
push the foot pedal inwards.
a Set side brush speed to suit the sweeping job.
b The side brush speed can be reduced to a minimum using
the twist knob in order to minimise the swirling up of dust.
c The side brush only starts up if the roller brush is switched
on.
5. To take on larger objects (50 mm), briefly open the coarse dirt
flap.
6. Clean the dust filter from time to time. To do so, move the man-
ual filter cleaner several times back and forth.
Emptying the waste container
Transport rolls
1
Waste container
2
Waste container lock
3
1. Clean the dust filter with the manual filter cleaner.
2. Open the lock on the waste container.
3. Pull out the waste container.
4. Empty the waste container.
When emptying the waste container, make sure that the seal-
ing strip does not become damaged.
5. Raise the waste container at the front and push it in all the way.
6. Check whether the waste container has clicked into place.
Stopping and parking the device
1. Take your foot from the accelerator.
2. Raise the roller brush and side brush.
3. Remove the ignition key.
4. Charge the battery.
5. Empty the waste container.
6. Only park the device on an even surface (< 2% gradient).
CAUTION
Risk of injury and damage
Be aware of the weight of the device during transportation.
1. The device has 4 marked lashing points. They are for use
when fastening the device.
2. When transporting the device on vehicles, secure it to prevent
it from slipping or overturning in accordance with the respec-
tive valid guidelines.
WARNING
Risk of injury and damage
Note the weight of the device.
1. Place the device in a dry, protected place on an even surface.
2. Remove the ignition key.
3. Clean the vehicle inside and out.
4. Disconnect the battery plug connector.
5. Recharge the battery every 2 months.
Care and maintenance
DANGER
Risk of accidents and injuries due to unintentional move-
ment of the device
Switch off the device before carrying out any care and mainte-
nance work, and remove the ignition key.
Disconnect the central battery plug connector.
Note
● Adhere to the safety instructions for care and maintenance.
CAUTION
Risk of short circuits due to water stream
Do not clean the device with a hose or high-pressure water jet.
DANGER
Health risk from dust
Wear a dust mask and safety goggles when cleaning with com-
pressed air.
ATTENTION
Risk of damage to the surfaces
Do not use any scouring agents or aggressive cleaning agents for
cleaning purposes.
1. Blow out the inside of the device with compressed air.
2. Clean the inside and outside of the device with a damp cloth,
soaked in mild washing lye.
English
Transport
Storage
General notes
Cleaning the device
23