Kärcher KM 85/50 R Bp Manual De Instrucciones página 25

Installing the roller brush
Roller brush
1
Brush roller mount
2
Forwards direction of travel
3
1. Pull out the roller brush.
2. Check for wear and entangled pieces of tape.
3. As necessary: Install the new roller brush.
4. When installing, make sure that it is installed in the correct po-
sition (the brush roller mounts are identical).
5. Install the cover plate and bearing plate in reverse order.
Replacing the side brush
Side brush
1
Screws
2
1. Unscrew the 3 screws on the underneath.
2. Remove the side brush.
3. If necessary, clean the mount.
4. Connect the new side brush to the driver and fasten it in place
with the screws.
Replacing the dust filter
DANGER
Health risk from dust
Wear a dust mark and safety goggles when working on the filter
system.
Dust filter (flat filter)
1
Frame
2
Hold-down plate
3
1. Shut down the device safely.
2. Clean the dust filter with the manual filter cleaner.
3. Completely open and secure the cover.
4. Remove the hold-down plate.
5. Remove the dust filter upwards.
6. As necessary: Clean the dust filter. (vacuum or carefully tap it
out) or insert a new dust filter.
Replacing / setting the sealing strips
Sealing strips
Side sealing strips
Front sealing strip
Rear sealing strip
Note
The trailing distance of the front and rear sealing strip defines
how much the sealing lip folds backwards when driving the de-
vice forwards.
When set correctly, there must be a gap between the side sealing
strips and the floor.
Fastening
1
Side sealing strip
2
Front sealing strip
3
Rear sealing strip
4
1. Unfasten the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
3. Refer to the table for the values.
4. Once the settings are correct, fasten the sealing strips.
English
Settings
Distance from floor 2 - 3 mm
Trailing distance 10-15 mm
Trailing distance 5-10 mm
25