Publicidad
INTRODUCTION
This installation instruction covers parts or accessories manufactured or marketed by Volvo Penta and used
in the specified application and for the intended purpose recommended by Volvo Penta. Any use other than
those specified may give unpredictable results and result in equipment failure or personal injury.
Proper preparation is extremely helpful for efficient service work. A clean work area at the start of the job
will minimize tools and parts becoming misplaced. Obtain tools, instruments and parts needed for the job
before work is started. Interrupting a job to locate special tools or repair kits is a needless delay.
When following these instructions the installer must adhere to all U.S. Coast Guard Safety Regulations and
ABYC Recommendations and Standards, or other regional regulation that may be in effect.
SERVICE POLICY
Whether within or following the warranty period, Volvo Penta has a constant interest in our products.
It is Volvo Penta's policy to provide dealers with service knowledge so they can give professional service
demanded by today's consumer. Volvo Penta Service Schools, frequent mailing of Service Bulletins,
Letters and Promotions, Special Tools and these instructions represent Volvo Penta's efforts in giving
consumers the best and most prompt service possible. If a service question does not appear to be
answered in these instructions, you are invited to call or write to the Volvo Penta Service Department for
additional help. Always be sure to give complete information, including engine model and serial number.
Be sure you are familiar with Volvo Penta's Warranty. If you have any questions, call or write the Volvo
Penta Service Department. If other than genuine Volvo Penta parts and components are used, Volvo Penta
may refuse subsequent warranty claims involving that engine.
When a brand-name product or specific tool is specified, another item may be used. However, the
substitute must have equivalent characteristics, including type, strength, and material. It is your
responsibility to determine if incorrect substitution could result in product malfunction and personal injury to
anyone. To avoid hazards, equivalent products which are used must meet all U.S. Coast Guard Safety
Regulations and ABYC standards.
REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS
Volvo Penta reserves the right to make changes at anytime, without notice, to specifications, models, and
procedures. Also, the right to change any specifications or parts at any time without incurring any obligation
to equip same models manufactured prior to date of such change. All information, photographs, illustrations,
and specifications, contained in these instructions are based on the latest information available at the time
of printing.
Photographs and illustrations used in this instruction may not depict actual models or equipment. The
continuing accuracy of this installation instruction cannot be guaranteed.
Use the general torque specification for all fasteners unless otherwise specified in the instructions.
IMPORTANT SAFETY NOTICES
Carefully observe the safety alert symbols below for dangers, warnings, and cautions. They alert installers
and operators of possible dangers or important information contained in this manual.
Warnings alone do not eliminate hazards. They are no substitute for professional workmanship and
proper installation.
DANGER!
death to boat operator, boat occupants, and/or others.
WARNING!
erator, boat occupants and/or others.
CAUTION!
equipment.
NOTE!
Special attention should be used to prevent incorrect assembly or disassembly.
Failure to comply with a danger symbol will result in serious injury or
Failure to comply with a warning may result in injury or death to boat op-
Failure to comply with a caution may result in failure or damage to the
1
Publicidad
