cecotec CONGA POPSTAR GLASS TITANIUM Manual De Instrucciones página 21

ENGLISH
Warning
Remove the water-collecting tank before charging the battery.
3. ASSEMBLY
Product assembly. Fig. 2.
Hold the main body with one hand and the cleaning head with the other. Push the cleaning
head against the main body until it clicks.
Spray bottle. Fig. 3.
Disattach the mop Velcro (6) and insert it in the upper plastic of the bottle by the ends. Attach
the mop Velcro.
4. OPERATION
- Press the power switch to turn the device on.
- The on indicator will be green as long as the battery is charged. When the battery is low, the
green light will start flashing. Charge the machine. When there is no charge, the indicator
will turn flashing red. The appliance will turn automatically off.
Use modes (Fig. 4)
The device can be used to clean mirrors, windows, tiles, glass doors, etc. in vertical direction. It
can only be used to clean table surfaces, tile floors, etc. in horizontal direction.
Steps (Fig. 5)
- Pour the water slowly into the spray bottle. Press the sprayer when the bottle is full.
- Turn the spray bottle setting button to change between water mist and water spray.
- Direct the sprayer towards the surface to be cleaned, press the spray bottle trigger and
spray water evenly on the surface.
- Use the spray bottle mop to clean the surface dirt.
- Place the Conga Popstar Glass Titanium vacuum cleaner to remove the used water from
the surface to be cleaned.
Note:
The water in the tank cannot exceed the maximum line indicated in the tank. Empty the used
water as soon as possible. It can affect the vacuum cleaner performance.
CONGA POPSTAR GLASS TITANIUM
40
Charing the device (Fig. 6)
Warning:
Before charging the vacuum cleaner, empty the used water tank.
- Open the blue tab and connect the USB cord to the device. After that, connect the adapter
to the USB cord and to the electric circuit.
- Charging time is approximately 2 hours. Remember that this information may vary
depending on the battery charge level and shelf life, among other factors.
- The operation indicator will turn red. It means the device is charging.
- When the indicator turns green, the charge will be complete.
- Remove the charger from the power socket and unplug the USB cord from the vacuum
cleaner.
Note:
- Use only the charger provided by Cecotec.
- When the charger outlet is over 5 V, the power indicator will flash in red and green
alternately. The vacuum cleaner will not be able to charge.
5. CLEANING AND MAINTENANCE
How to empty the used water tank (Fig. 7)
1. Turn off the vacuum cleaner.
2. Hold the vacuum cleaner by its handle.
3. Open the water cap from the device.
4. Empty the tank.
5. Close the cap.
Note:
- Empty the water tank when waste water reaches the maximum line.
- Empty the water tank every time you use the machine to avoid unpleasant smells after a
long storage of waste water.
- Empty the tank before charging the vacuum cleaner.
Cleaning the water tank
- It is important to keep the water tank clean. It gets dirty after extended use.
- Open the blue tab.
- Add clean water in the water tank.
- Shake the product slightly.
ENGLISH
CONGA POPSTAR GLASS TITANIUM
41