Burley Piccolo Instrucciones Del Propietario página 9

Trailercycle Assembly
1
Insert tow bar into frame coupling and
align so that detent engages in detent hole
on frame as shown above. Progressively
tighten clamp bolts with a 5mm hex wrench,
alternating between bolts every 1-2 nm
until both bolts are at 6-8 nm (4-6 ft-lb).
Hitching Your Trailercycle to Your Bicycle
1
Ensure your trailercycle rack is safely installed
on your bicycle per the instructions provided
with the rack. Slide lever to retract safety pins.
PICCOLO & KAZOO
2
Mount pedals (stamped r for right and L
for left) to the corresponding crank arm
and tighten.
Left pedal uses left hand threads
(counter-clockwise to tighten).
2
Set hitch on rack as shown.
Ensure that lever rotates back
to fully engage pins.
ENG DEU
3
remove stem face plate, place handlebar
into clamp and replace face plate.
center handlebar and tighten face
plate bolts to 4-5 nm (3-3.7 ft-
lb) with a 4mm hex wrench.
3
Push knob down to engage hitch with
rack. rotate knob clockwise.
Fully tighten hitch knob.
FRA ESP
4
remove bolts on bottom of stem.
Align fender with holes and
fasten to trailercycle (4-5 nm)
with a 3mm hex wrench.
Insert flag into flagholder
(inside left dropout).
IMPORTANT
KnoB MuSt BE tIGHtEnEd
And SAFEtY PInS EnGAGEd
BEForE uSE. do not
uSE Your trAILErcYcLE
IF You ArE unABLE to
SEcurELY tIGHtEn KnoB
or GEt FuLL EnGAGEMEnt
oF tHE SAFEtY PInS.
9
ASSEMBLY & uSE