Emos P5728T Manual De Instrucciones página 3

GB | Replacement Button
Designed for wireless doorbell P5728.
Specifications
Transmission range: up to 180 m in an open area (can drop down
to one fifth in a busy area)
Transmission frequency: 433.92 MHz, 5 mW e.r.p. max.
Button: water resistant; enclosure rating IP56
Pairing of chime with buttons: self-learning function
Button power supply: 1× 12 V battery (type A23)
Includes: double-sided adhesive tape
Button Description
(see Fig. 1)
1 – ring button
2 – button LED
Removing the Button's Battery Cover/Installing the Button
(see Fig. 2)
Chime Description
(see Fig. 3)
1 – bell LED
2 – battery compartment
3 – holes for hanging
4 – speaker
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver
into the hole on the bottom side. Insert a 12 V type A23 battery
in the button. When inserting a battery, make sure to observe
the correct polarity!
2. Insert 3× 1.5 V AAA batteries into the chime. When inserting the
batteries, make sure to observe the correct polarity. Use alkaline
batteries only; do not use re-chargeable batteries.
3. Long-press (ca. 4 seconds) the pairing button
a tone will sound. The chime will switch to self-learning pairing
mode which lasts for 25 seconds. During this time, press the
3 – hole for opening the
battery cover
4 – battery compartment
5 – ringtone change button
6 – pairing/volume setting
button
3
on the chime;