Emos P5728T Manual De Instrucciones página 4

ring button. The chime will ring and the button is now paired
with the chime. This automatically ends self-learning mode.
4. Re-assemble the button.
5. To pair multiple buttons, repeat the process for each button
from step 1.
Wiping the Memory of Paired Buttons
Insert 2 AAA batteries into the doorbell, then press and hold the
button. Insert the remaining third AAA battery into the doorbell. The
doorbell's LED will flash and then remain lit. Release the
the LED will turn off. This will erase the memory of all paired buttons.
Installation of the Doorbell (Transmitter) Button
1. Begin by pairing the button with the chime.
2. Before installation, check that the pair works reliably in the
chosen spot.
3. Remove the rear cover with a screwdriver through a hole on
the side of the button.
4. Use the double-sided adhesive tape (included) or two screws to
fix the rear portion of the cover to the wall. Although the button
is weather resistant, choose a location where it is protected,
e.g. in a wall recess.
5. Re-assemble the button.
6. Press the button to ring the chime. Pressing is accompanied by
LED illumination indicating the button has sent a radio signal.
The chime plays the selected ringtone.
Note: The doorbell button (transmitter) can be placed on wood or
brick walls without issue. However, never place the button directly
onto metal objects or materials containing metal, such as plastic
windows or doors that have a metal frame. In such cases, the
transmitter will not work properly.
Upkeep and Maintenance
The wireless digital doorbell is a sensitive electronic device. There-
fore, it is necessary to observe the following precautions:
• The chime (receiver) is designed for indoor use in dry envi-
ronments only.
4
button;