Andis US-1 Instrucciones De Uso Y Cuidado página 6

USER MAINTENANCE
The internal mechanism of your clipper has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.
POWER ADJUSTMENT
Your Andis clipper has been adjusted to line voltage at the factory. However, because
of voltage variations, it may be necessary to adjust the power setting for your area.
If the power adjustment is off, you will usually notice a "clatter" when the clipper is
on or introduced into the hair. (It is normal for your clipper to "clatter" for an instant
when initially turned on).
TO ADJUST YOUR CLIPPER
1. Oil the blades.
2. The power screw is located in the lower part of the housing opposite the switch
(Figure D).
3. Turn your clipper ON.
4. Using a standard screwdriver that fits the slot, turn the power screw clockwise until
the clipper clatters continuously. Then turn the screw counterclockwise carefully
until the clatter ceases.
5. Your clipper is now adjusted to its optimum power setting.
The power screw is a special part and it must not be replaced by any other screw
except the original part of the appliance.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. If
you have a detachable blade unit, you can change your blade in order to maintain a
comfortable temperature; using multiple blades of the same size is popular among
groomers.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
The blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign that the blades need oil. The clipper
6