Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE — LARGE COVER
7. Pass the flush pipe and the
vacuum breaker through the
guide hole (Step 4) and
mount them on the bowl.
8. If required, cut the vacuum
breaker tube to the proper
length.
9. Make sure that the o-ring fits in the groove
at the end of the Flush Valve tailpiece.
NOTE: Exercise care to avoid damaging the
o-ring when inserting the tailpiece
into the control stop. If lubrication is
needed, wetting the o-ring with water
is sufficient.
10. Connect the Flush Valve to the control stop
and vacuum breaker tube.
TET2LB32, TET2GB32
TET2UB32
7" (178 mm) Min space
requirement in wall
Wall surface
6~6-1/2"
(152~165 mm)
1-1/2" (38 mm)
or 3/4" (19 mm)
Top spud
5"
(127 mm)
2-1/4"~2-3/4"
(57~70 mm)
3-3/4"~4-7/8"
Bowl
(95~124 mm)
TET2LB33, TET2UB33
TET2GB33
7" (178 mm) Min space
requirement in wall
Wall surface
Back spud
Floor mount
3-3/4"~4-7/8"
Bowl
(95~124 mm)
- 8 -
TET2LB31, TET2UB31
TET2GB31
7" (178 mm) Min space
requirement in wall
Wall surface
Back spud
Wall mount
3"
(76 mm)
Bowl
1-1/2"
(38 mm)
Snap ring
1-1/2"
(38 mm)
3-3/4"~4-7/8"
(95~124 mm)
O-ring
Publicidad
