STAMOS S-MIG 350H Manual De Instrucciones página 20

1. Welding voltage display.
2.
Welding current display.
Welding function selection:
2T / 4T for MIG / TIG:
•
3.
•
4. Welding mode selection: MIG / MAG or MMA
5. CHECK WIRE - wire feed button
6. CHECK GAS - shielding gas flow check button
7. POWER - power indicator
OC - thermal overload indicator light - when the device overheats, this light turns on
and the device turns off. Do not try to restart welding by leaving the machine with the
8.
fans running. The indicator will automatically turn off when the device cools down.
Pay attention to the rated duty cycle.
Adjustment knob:
9.
•
•
Adjustment knob:
10.
•
•
11. Inductance adjustment knob for MIG / MAG welding
Welding machine connection sockets:
2T - pressing the button on the welding torch initiates the process of
welding/cutting the metal and releasing the button ends the process.
4T - pressing the button on the welding torch initiates the process of
welding/cutting the metal, releasing the button does not end the process.
Pressing and releasing the button again completes the metal welding process.
welding current for MMA welding
final welding voltage for MIG / MAG welding
ARC FORCE (arc dynamics control) for MMA welding
final welding current for MIG / MAG welding