Cameo F4 D PO IP Manual De Usuario página 10

INSTALLATION, MOUNTING AND SETTING WITH OPERATING ROD
Thanks to its four plastic feet, the spotlight can be positioned in a suitable location on a level surface. Mounting to a truss is possible using
the built-in 28 mm TV spigot (A) and a suitable TV truss clamp (not supplied). Ensure firm connections and secure the spotlight by attaching
a suitable safety cable to the point intended for this purpose on top of the housing (B). Use the side-mounted yellow operating knob (C) to
set the beam angle (zoom) with an operating rod. The blue operating knob (D) is for setting the beam direction on the horizontal axis (pan)
and the white operating knob (E) is for setting the beam direction on the vertical axis (tilt). The slip clutch in the drive unit for adjusting tilt
can be set with a 6 mm hex tool (F).
Important safety information Overhead installation requires extensive experience, which includes calculating the limit
values of the working load of the installation material to be used and regular safety inspections of all installation material and
spotlights. If you do not have these qualifications, do not attempt to carry out the installation yourself; contact a professional
company.
BARNDOOR AND FILTER FRAMES: INSTALLING/REMOVING & CLEANING LENSES
Fully disconnect the device from the mains. To install or remove the barn door and the filter frame, please push the spring-loaded locking
pin (A) of the bracket so that it folds upwards. Then return the bracket to its original position so that the locking pin re-engages. The Fresnel
lens (B) is in a rubber frame and the glass lens (C) is located behind it. These can be cleaned by folding the bracket upwards (as previously
described) and removing the Fresnel lens, with the rubber frame, upwards out of the angle brackets. Clean the Fresnel lens with a moist,
lint-free cloth and the glass lens with a special lens cloth. Now place the Fresnel lens in front of the glass lens and fold the bracket back
downward until the locking pin engages.
A
Important safety notice!
For safety reasons, the filter frame must always be in the respective bracket on the spotlight, even if no filter is inserted!
10
A
F
E
D
C
B
B
C