Dolmar SP-7650.4 R Manual De Instrucciones Original página 11

ASSEMBLY INSTRUCTIONS
Assembling mist blower pipes
CAUTION:
Be ore per orming any work on the mist blower, always stop the engine and pull
the spark plug connectors o the spark plug.
Always wear protecti e glo es
Start the mist blower only a ter ha ing assembled it completely.
Make sure that all the hose bands are tight a ter assembly.
NOTE:
Make the band s bolt heads come outer side when you tighten them as illustrated.
1. Assemble the swi el pipe 1 with the e ible pipe 2 .
ighten them with the 76 mm diameter band 3 .
2. Assemble the e ible pipe with the elbow 4 o the mist blower.
ighten them with the 100 mm diameter band 5 .
3. Assemble the straight pipe 6 with the swi el pipe 1 .
Align the groo e o the straight pipe with the projection on the swi el pipe, and
turn the straight pipe until it clicks, and then tighten them with the 76 mm diameter
band 3 .
NOTE:
he straight pipe stated abo e means the ollowing three pipes and can be
substituted depending on your work need.
Straight pipe long 6
Bent top pipe 7
Straight pipe short 8
hen using the straight pipe long 6 or the bent pipe 7 , use with tube long
.
hen using the straight pipe short 8 , use with tube short 10 .
o replace a tube, the hose clamps need to be remo ed and assembled.
pliers or a similar tool, i necessary.
CAUTION:
hen replacing the tube, be care ul not to damage it.
nly one or combination o the abo e pipes is supplied as a standard e uipment
with your mist blower, which may di er rom country to country.
he remaining types o pipes may need to be obtained as optional accessories.
( )
se
( )
( )
11
( )
( )
( )
( )
( )
( )
(1)
( )