Dolmar SP-7650.4 R Manual De Instrucciones Original página 19

Mist blower operation
o increase engine speed, grasp the control handle the lock-o le er is released by
the grasp and pull the throttle trigger.
ressure on the throttle trigger controls engine speed.
osition o the stop control le er can restrict the angle o the throttle trigger.
here are our positions or the stop control le er.
throttle trigger angle restriction positions.
position does not restrict the engine speed you can pull the throttle trigger ully .
he throttle trigger angle gets restricted rom one step abo e the
throttle trigger is more restricted when you mo e the stop control le er one more step
abo e the position.
Adjust engine speed appropriate or the work location and conditions during operation.
Liquid adjustment knob
i uid adjustment knob allows a wide range o di erent discharge rates.
Adjusting the discharge rate
urn the li uid adjustment knob 1 on the second no le to obtain the desired
discharge rate so that the number on the li uid adjustment knob is aligned with the
triangle marking 2 .
ischarge rate
Spray holding the straight pipe with the angle o 0 degrees to minus degrees to the hori ontal.
Knob position
1
2
3
4
NOTE:
se the gures shown in the abo e table as a guide line or operation and these may be changed according to the density o chemical solution
used in the solution tank.
Solution discharge lever
o start the solution eeding A , turn the solution discharge le er 1 hori ontally to
the pipe.
o stop the solution eeding B , turn the solution discharge le er ertically to the pipe.
engine stop ,
ischarge rate min mean alue
0.36
1.0
1.6
2.5
, and two
position. he
1
( )
(1)
( ) ( )
(1)