Dolmar SP-7650.4 R Manual De Instrucciones Original página 16

NOTE:
he engine may be damaged i the choke le er is mo ed urther beyond the C
the engine stops with an e plosion sound or i the engine started, but stopped be ore operation o the choke le er, return it to the
position and pull the starter handle se eral times to start the engine again.
the operator keeps pulling the starter handle se eral times with the choke le er le t in the C
start because o o er-suction o the uel.
n case o o er-suction o the uel, remo e the spark plug and pull the handle se eral times rapidly to discharge any e cess uel. ry the spark
plug electrode.
hen the throttle al e does not return to a position in contact with the idling adjusting screw e en i the throttle trigger is set to the low speed,
correct the control cable catching state to ensure proper return o the al e.
2) When the engine is warm (warm start)
1 lace the engine on a at ground.
2 ress the primer pump se eral times.
3 Make sure that the choke le er is down.
4 old the air cleaner co er with a le t hand to pre ent the engine rom mo ing, settle down to take the stable position.
5 ull the starter handle slowly until eeling compression. hen pull it strongly.
6 hen the engine is di cult to start, open the throttle al e by 1 3.
2. Stopping
1 elease the throttle trigger to reduce the engine speed, and set the stop
control le er to the
ADJUSTING IDLE SPEED
DANGER:
he adjustment o the carburetor is completed at the time o actory shipment. lease do not adjust other than idling adjusting.
becomes necessary, please consult your authori ed ser ice center.
Checkup of idle speed
Set the idle speed rotation to 2,800 min
it is necessary to change the rotation speed, regulate the adjusting screw 1 ,
with hillips screwdri er.
urn the adjusting screw to the right, and the engine rotation will increase. urn the
adjusting screw to the le t, and the engine rotation will drop.
position.
.
1
SE position.
16
SE position, the engine may be di cult to
hen adjustment
(1)
EN